Mazda CX-3: Owner Maintenance / Engine Coolant

Mazda CX-3 (2015-2024) Owner's Manual / Maintenance and Care / Owner Maintenance / Engine Coolant

Inspecting Coolant Level

WARNING

Do not use a match or live flame in the engine compartment. DO NOT ADD COOLANT WHEN THE ENGINE IS HOT: A hot engine is dangerous. If the engine has been running, parts of the engine compartment can become very hot. You could be burned. Carefully inspect the engine coolant in the coolant reservoir, but do not open it.

Pull over to a safe location, then switch the ignition off and make sure the fan is not running before attempting to work near the cooling fan: Working near the cooling fan when it is running is dangerous. The fan could continue running indefinitely even if the engine has stopped and the engine compartment temperature is high. You could be hit by the fan and seriously injured.

Do not remove either cooling system cap when the engine and radiator are hot: When the engine and radiator are hot, scalding coolant and steam may shoot out under pressure and cause serious injury.

NOTE

Changing the coolant should be done by an Authorized Mazda Dealer.

Inspect the antifreeze protection and coolant level in the coolant reservoir at least once a year―at the beginning of the winter season―and before traveling where temperatures may drop below freezing.

Inspect the condition and connections of all cooling system and heater hoses. Replace any that are swollen or deteriorated.

The coolant should be at full in the radiator and between the F and L marks on the coolant reservoir when the engine is cool.

Mazda CX-3. Engine Coolant

If it is at or near L, add enough coolant to the coolant reservoir to provide freezing and corrosion protection and to bring the level to F.

Securely tighten the coolant reservoir tank cap after adding coolant.

CAUTION

Radiator coolant will damage paint. Rinse it off quickly if spilled.

If the “FL22” mark is shown on or near the cooling system cap, use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL-22 may cause serious damage to the engine and cooling system.

Mazda CX-3. Engine Coolant

If the coolant reservoir is empty or new coolant is required frequently, consult an Authorized Mazda Dealer.

Inspecting Engine Oil Level

Be sure the vehicle is on a level surface. Warm up the engine to normal operating temperature. Turn it off and wait at least 5 minutes for the oil to return to the oil pan...

Brake/Clutch Fluid

Inspecting Brake/Clutch Fluid Level WARNING If the brake/clutch fluid level is low, have the brakes inspected: A low brake/clutch fluid level is dangerous...

Other information:

Mazda CX-3 (2015-2024) Owner's Manual: Fuel Requirements

Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED FUEL, which will reduce exhaust emissions and keep spark plug fouling to a minimum. To achieve maximum engine performance, use the specified fuel. *1 U.S. federal law requires that octane ratings be posted on gas station pumps...

Mazda CX-3 (2015-2024) Owner's Manual: Seat Belt Extender

If your seat belt is not long enough, even when fully extended, a seat belt extender may be available to you at no charge from your Authorized Mazda Dealer. This extender will be only for you and for the particular vehicle and seat. Even if it plugs into other seat belts, it may not hold in the critical moment of a crash...